RV Wiring Devices

This threaded ring is compatible with most 30A RV and marine inlets. It fits over a weatherproof boot and screws over an inlet to provide maximum protection against the elements.

*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.

This 50A assembly connector comes in a black nylon body and features a 45 degree downward angle for strain relief. A threaded ring is included that securely fits around the inlet to create a watertight seal, helping to protect the connection from water damage.

Limited one year warranty

This 50A NEMA 14-50 assembly replacement plug is constructed of a durable black nylon body and comes in a 45° downward angle for strain relief. It is designed for use with STW 6/3 8/1 cable as well as STW 6/4 cable.

Limited one year warranty

This straight blade NEMA 14-50P assembly/replacement plug has a nylon body and is a grab cord type. It can be used to create or rewire a RV, generator, range, or other power cord that would use this configuration.

Limited one year warranty

This 50A, 14-50 assembly connector can be used to wire a new cord or rewire an existing cord with the same configuration. It is a straight bladed, grab cord type with a black nylon body. The 14-50 configuration is commonly used with RVs, generators, electric vehicles, and industrial usage.

Limited one year warranty

These replacement oval bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has three screw holes that will attach to the existing setup.

Limited one year warranty

These replacement square bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has four screw holes that will attach to the existing setup. They are available in either black, white, or stainless steel.

Limited one year warranty

This weatherproof boot is designed to work for both 50A male plugs and female connectors to provide protection against the elements.

Limited one year warranty

This threaded sealing collar bridges the connection between two 50A power cords equipped with weatherproof boots and rings to provide maximum water protection. It is ideal for running multiple marine, RV, or temp power cords over extended lengths.

Limited one year warranty

This weatherproof boot and ring combo is designed to work with female locking connectors that are rated for 30 amps. The included threaded ring screws around an inlet or a sealing collar on a cord to prevent water damage at the connection.

Limited one year warranty

This locking 30A assembly connector comes in a black nylon body and features a 45 degree downward angle for strain relief. A threaded ring is included that securely fits around the inlet to create a watertight seal, helping to protect the connection from water damage.

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

This 30A straight blade configuration style is commonly found on power cords for generators and is the standard for 30A service at RV parks. The assembly plug features a clamp grip for easy wiring, while the right angle provides strain relief to the cord, allowing the RV pedestal to fully close.

Limited one year warranty

This 30A assembly straight plug is designed for RVs and generators using this configuration. It has a standard inline design and is built with impact resistant nylon to withstand years of usage. The gasket, compression ring, and tight screw are all included.

Max Grip Cable: OD: 18.5mm

Limited one year warranty