RV Wiring Devices

This threaded sealing collar bridges the connection between two 50A power cords equipped with weatherproof boots and rings to provide maximum water protection. It is ideal for running multiple marine, RV, or temp power cords over extended lengths.

Limited one year warranty

These replacement oval bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has three screw holes that will attach to the existing setup.

Limited one year warranty

These replacement square bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has four screw holes that will attach to the existing setup. They are available in either black, white, or stainless steel.

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

This 30A assembly straight plug is designed for RVs and generators using this configuration. It has a standard inline design and is built with impact resistant nylon to withstand years of usage. The gasket, compression ring, and tight screw are all included.

Max Grip Cable: OD: 18.5mm

Limited one year warranty

This 30A TT-30R straight blade assembly/replacement connector can be attached to power cords that are commonly used with generators and RVs. It features a black nylon body and is a bladed grab cord type. The straight connector design allows it to connect directly to an inlet or other power cord.

Max Grip Cable: OD ø18.5mm

Limited one year warranty

This straight blade NEMA 14-50P assembly/replacement plug has a nylon body and is a grab cord type. It can be used to create or rewire a RV, generator, range, or other power cord that would use this configuration.

Limited one year warranty

This 50A, 14-50 assembly connector can be used to wire a new cord or rewire an existing cord with the same configuration. It is a straight bladed, grab cord type with a black nylon body. The 14-50 configuration is commonly used with RVs, generators, electric vehicles, and industrial usage.

Limited one year warranty