Marine Wiring Devices

This 50A threaded ring can be attached to a weatherproof boot as a replacement if one breaks or strips. This ring is made of high impact ABS plastic and fits snugly over the weatherproof boot by using a heat gun or hair dryer to warm it up.

This threaded sealing collar bridges the connection between two 50A power cords equipped with weatherproof boots and rings to provide maximum water protection. It is ideal for running multiple marine, RV, or temp power cords over extended lengths.

Limited one year warranty

This weatherproof boot and ring combo is designed to work with female locking connectors that are rated for 30 amps. The included threaded ring screws around an inlet or a sealing collar on a cord to prevent water damage at the connection.

Limited one year warranty

These 30 amp NEMA L5-30 locking assembly plugs can be used to wire a new cord or replace a plug with the same configuration. It comes in either a black or yellow nylon body with a rear cord clamp for easy wiring.

•Bladed Grab Cord Type

Max Grip Cable: OD ø16.5mm

Limited one year warranty

This 3-prong locking connector is commonly used with RV, marine, and generator applications. It can be used to replace a connector that has the NEMA L5-30R configuration. The connector is made with a black nylon body that is resistant to impact.

•Hexagonal Cable Clamp

Max Grip Cable: OD ø16.5mm

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

This 50A 125V locking assembly plug is steel encased with a yellow body. It has the NEMA SS1-50 configuration that is typically used at older marine shore pedestals.

Limited one year warranty