Marine Wiring Devices

This threaded ring is compatible with most 30A RV and marine inlets. It fits over a weatherproof boot and screws over an inlet to provide maximum protection against the elements.

*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.

These replacement oval bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has three screw holes that will attach to the existing setup.

Limited one year warranty

These replacement square bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has four screw holes that will attach to the existing setup. They are available in either black, white, or stainless steel.

Limited one year warranty

This weatherproof boot is designed to work for both 50A male plugs and female connectors to provide protection against the elements.

Limited one year warranty

This threaded sealing collar bridges the connection between two 50A power cords equipped with weatherproof boots and rings to provide maximum water protection. It is ideal for running multiple marine, RV, or temp power cords over extended lengths.

Limited one year warranty

This weatherproof boot and ring combo is designed to work with female locking connectors that are rated for 30 amps. The included threaded ring screws around an inlet or a sealing collar on a cord to prevent water damage at the connection.

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

This 50A threaded ring can be attached to a weatherproof boot as a replacement if one breaks or strips. This ring is made of high impact ABS plastic and fits snugly over the weatherproof boot by using a heat gun or hair dryer to warm it up.

This sealing collar and threaded ring combo bridge the gap between two 30A power cords to prevent water damage. Another 30A power cord with a weatherproof boot and ring will fit on the other side, keeping the connection safe from the elements.

*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.