Marine Shore Power

This IEC 309 to ROJ power cord is rated at 32A 200~250V and is typically used for industrial purposes. The female end has the outer jacket removed for easily wiring an assembly connector or to hard wire into equipment.

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

These marine shore power cords have the older 50A 125V SS1-50 configuration. Both the male plug and female connector are surrounded by weatherproof boots that include threaded rings to help create a watertight seal at the connection.

Approval: Plug, Connector, and STOW: UL, C-UL

Limited one year warranty

*Derated to 45 Amps when the cable is longer than 50FT

These marine shore power cords have the older 50A 125V SS1-50 configuration. Both the male plug and female connector are surrounded by weatherproof boots that include threaded rings to help create a watertight seal at the connection. Available in either 25ft. or 50ft. lengths.

Approval: Plug, Connector, and STOW: UL, C-UL

Limited one year warranty

*Derated to 45 Amps when the cable is longer than 50FT

This 50A threaded ring can be attached to a weatherproof boot as a replacement if one breaks or strips. This ring is made of high impact ABS plastic and fits snugly over the weatherproof boot by using a heat gun or hair dryer to warm it up.

This sealing collar and threaded ring combo bridge the gap between two 30A power cords to prevent water damage. Another 30A power cord with a weatherproof boot and ring will fit on the other side, keeping the connection safe from the elements.

*Please note that a heat gun or similar device will be required when using as a replacement on a power cord.

This IEC 309 5-pin IP67 power cord has a watertight plug and terminal ends for easy wiring. It is typically used for standard industrial purposes.

Limited one year warranty