Marine Shore Power

These 50 amp inlets are designed to work with the older SS1-50 125V configuration. The white model is constructed of marine grade UV stabilized glass-filled polyester, while the other model is stainless steel. Both feature a watertight cap that protects the inlet when not in use as well as the rear safety enclosure.

Limited one year warranty

These L5-30 power inlets are designed for use with both marine and RV applications and can be easily installed as a replacement inlet. They are constructed of marine grade UV stabilized glass-filled polyester for long lasting durability. Each model includes a protective cap to seal out the elements when not in use, while also including a smart cap feature that keeps the cap in an upright position when open. The rear of the inlet contains a 8-way right angle rear safety enclosure for strain relief.

Limited one year warranty

These 20A flanged inlets feature a nylon casing and a weatherproof cap when not being used. Easily wire a power source for RVs, boats, etc. using one of these inlets.

Approval: UL, C-UL

Limited one year warranty

These 15A flanged inlets (NEMA 5-15P) feature a nylon casing and a weatherproof cap to protect the inlet when not being used. Easily wire a connection for RVs, boats, or equipment such as block heaters.

Approval: UL, C-UL

Limited one year warranty

This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the

Max Grip Cable: OD ø17.5mm

These replacement square bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has four screw holes that will attach to the existing setup. They are available in either black, white, or stainless steel.

Limited one year warranty

These replacement oval bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has three screw holes that will attach to the existing setup.

Limited one year warranty

This adapter is useful in allowing a device with a L5-30 plug to connect to a L5-20 outlet. Please note there is no cover on the adapter, so it is not recommended that it be used in wet or damp conditions.

Limited one year warranty

These plug adapters are typically used with generators, RV, and marine pedestals that require a L5-30 connection when only a NEMA 5-15 outlet is available. They can be used to provide minimal power for charging a boat or RV battery.

Limited one year warranty