These 30A L5-30 power cords feature a yellow jacket that is covered with abrasion resistant orange braided PVC to extend the life of the cable. Both the plug and connector feature LED power indicator lights as well as threaded rings to ensure a watertight connection. The female connector also has a protective cap that covers it when not in use.
Approval: Plug, STOW, and connector: UL, C-UL
Limited one year warranty
This IEC 309 to ROJ power cord is rated at 32A 200~250V and is typically used for industrial purposes. The female end has the outer jacket removed for easily wiring an assembly connector or to hard wire into equipment.
Limited one year warranty
These plug adapters are typically used with generators, RV, and marine pedestals that require a L5-30 connection when only a NEMA 5-15 outlet is available. They can be used to provide minimal power for charging a boat or RV battery.
Limited one year warranty
This adapter is useful in allowing a device with a L5-30 plug to connect to a L5-20 outlet. Please note there is no cover on the adapter, so it is not recommended that it be used in wet or damp conditions.
Limited one year warranty
These replacement oval bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has three screw holes that will attach to the existing setup.
Limited one year warranty
These replacement square bezels with caps are designed for Conntek's 30A or 50A inlets or outlets. Each one has four screw holes that will attach to the existing setup. They are available in either black, white, or stainless steel.
Limited one year warranty
This 30A assembly combo replaces the L5-30R connector commonly found on RV or marine shore power cords. The weatherproof boot fits over the female assembly connector to create a tight seal, while the threaded ring screws around the inlet to prevent water damage from occurring at the connection. A gasket, compression ring, and tight screw are all included with the
Max Grip Cable: OD ø17.5mm
These 15A flanged inlets (NEMA 5-15P) feature a nylon casing and a weatherproof cap to protect the inlet when not being used. Easily wire a connection for RVs, boats, or equipment such as block heaters.
Approval: UL, C-UL
Limited one year warranty
These 20A flanged inlets feature a nylon casing and a weatherproof cap when not being used. Easily wire a power source for RVs, boats, etc. using one of these inlets.
Approval: UL, C-UL
Limited one year warranty