Generator Wiring Devices

This assembly plug features a NEMA L14-30, 30A locking configuration and a black nylon body. It is a straight, bladed grab cord type.

Max Grip Cable: OD ø18.5mm

Approval: UL, C-UL

Limited one year warranty

This 30A, L14-30R assembly / replacement connector is commonly used with generators and backup systems.

Max Grip Cable: OD 16.5mm.

Limited one year warranty

This 20A 125V NEMA L5-20 assembly plug is commonly used to wire an existing or new cord for a generator or other device using this configuration. It is constructed of an impact resistant nylon body and includes a gasket, compression ring, and tight screw.

Max grip Cable: OD ø17.5mm

Approval: UL, C-UL

Limited one year warranty

These 30 amp NEMA L5-30 locking assembly plugs can be used to wire a new cord or replace a plug with the same configuration. It comes in either a black or yellow nylon body with a rear cord clamp for easy wiring.

•Bladed Grab Cord Type

Max Grip Cable: OD ø16.5mm

Limited one year warranty

This locking 30A assembly connector comes in a black nylon body and features a 45 degree downward angle for strain relief. A threaded ring is included that securely fits around the inlet to create a watertight seal, helping to protect the connection from water damage.

Limited one year warranty

This 3-prong locking connector is commonly used with RV, marine, and generator applications. It can be used to replace a connector that has the NEMA L5-30R configuration. The connector is made with a black nylon body that is resistant to impact.

•Hexagonal Cable Clamp

Max Grip Cable: OD ø16.5mm

Limited one year warranty

This 3-prong NEMA L6-20P male assembly plug is rated at 20A and 250V. It comes in a yellow nylon body and includes the gasket, compression ring, and tight screw needed for wiring.

Max Grip Cable: OD: 17.5mm.

Approval: UL & C-UL

Limited one year warranty

This 20A female assembly connector is typically used for 20 amp generator cords with the L6-20 configuration. It is constructed of a durable yellow nylon body with a easy to wire design.

Bladed Grab Cord type

Limited one year warranty

This 30A straight blade configuration style is commonly found on power cords for generators and is the standard for 30A service at RV parks. The assembly plug features a clamp grip for easy wiring, while the right angle provides strain relief to the cord, allowing the RV pedestal to fully close.

Limited one year warranty

This 50 amp NEMA SS2-50 marine shore power locking assembly plug comes in a heavy duty steel body surrounded by a hardened plastic case. It also has a center hole for connecting to a CS6364 connector that has the center pin. It can be used for wiring on to an existing cord as a replacement or for adding on to a new power cord.

Approval: UL, C-UL

Limited one year warranty

This 50A locking assembly connector comes in a black nylon body and features a 45 degree downward angle for strain relief. A threaded ring is included that securely fits around the inlet to create a watertight seal, helping to protect the connection from water damage.

Limited one year warranty

This 50A locking assembly connector comes has a nylon body and is a grab cord type. It is similar to a CS6364 connector, but this connector does not include the center guiding pin. Use as a replacement for RV, boat, generator, or other devices. These connectors are used in many industrial applications as well.

Applicable Cable Types:

Gauge: 6/4 : Jacket types: ST, STW, STOOW, STOW, SOW, SOOW)

Gauge: 6/3 8/1: Jacket types: (ST, STW, STOOW, STOW)

Approval:UL & C-UL

Limited one year warranty